نوع مقاله : مقاله پژوهشی
نویسندگان
1 عضو هیئت علمی مرکز تحقیقات کشاورزی استان آذربایجانشرقی و دانشجوی دکتری دانشگاه تبریز.
2 عضوهیئت علمی مرکز تحقیقات کشاورزی و منابع طبیعی استان آذربایجانشرقی.
چکیده
کلیدواژهها
عنوان مقاله [English]
نویسندگان [English]
Various tillage systems have different degrading and or beneficial effects on soil structure and aggregates of top layers and, thus, affect infiltration characteristic especially the infiltration rate and the slope of infiltration equation. The objective of this study was to evaluate the effect of tillage method and depth on infiltration, penetration resistance, plant available water, and crop yield in Tabriz plain in a clayey textured soil. In this study, four treatments including A1 (chisel plowing at 20 cm depth), A2 (moldboard plowing at 20 cm depth), A3 (moldboard plowing at 30 cm depth) and A4 (no tillage) were compared in three replications using a randomized complete block design. Results indicated that there was significant difference between treatments in infiltration rate at different time increments (1, 2, 5, 10, 30, 60, 120 and 180 min). Based on the slope of infiltration equations, the infiltration rate in A1 decreased more rapidly than the other treatments. Initial infiltration rate in A3 (482.8 mm hr-1) was higher than the other treatments, but differences between the other treatments were not significant. This difference may be attributed to tillage depth. Infiltration rate in A3 was higher than the other treatments but its preference in comparison with A4 (no tillage) just extended until 60 min and then declined rapidly. This result shows that the layer below the tillage depth controls infiltration rate after about 1.5 hr. In all the four measured layers (0-10, 10-20, 20-30 and 30-40 cm), A3 and A4 had the minimum and maximum penetration resistance, respectively. Effect of tillage treatments on plant available water and crop yield was not significant.
کلیدواژهها [English]